Rockit Key 
gprk
Rockit Key

• Advances ignition timing 10 degrees
• Increases acceleration and gain up to 2mph on top speed
• Works on G23, G2D & G230RC! engines
• Adds 8mph and 460rpm!
• Also available for BladeZ Moby 35/40cc Scooters

 

NOW also available for BladeZ Scooters!!

1) Remove fan cover, leaving pull start attached
2) Remove flywheel nut
3) Thread the 6mm puller bolt into one of the threaded holes in the flywheel
4) Tighten bolt against case behind flywheel(look for high spot on case) until flywheel pops off
5) Remove stock woodruff key from crankshaft
6) Wipe end of crankshaft clean
7) Apply a small amount of grease to crankshaft end and keyway
8) Install the Rockit Key with the offset on the right side(towards read of Go-Ped)
9) Re-install flywheel, lining up the keyway in the flywheel with the Rockit Key
10) Press flywheel on as far as possible by hand, it may be tight going onto Rockit Key
11) Install flywheel nut and tighten
12) Re-install fan cover
13) Re-check flywheel nut after first 5 minutes of use